LUHUI R51 foundation support rock soil anchor bolt is mainly used in underground engineering ,like weak surrounding rock, fault fracture zone, highland stress large deformation and other complex geology. especially in serious hole collapse and deep fault rock situation, ordinary anchor rod is incapable of action. LHZ anchor bolt set drilling, grouting, lengthen and anchoring multifunction all in one, in all kinds of bad surrounding rock engineering applications achieved ideal support effect.
  

 Application

Tunnelling                        Ground engineering

• Radial bolting                 • Slope stabilization
 
• Forepoling                      • Micro injection pile

• Face stabilization           • Temporary support anchor

• Portal preparation           • Soil nailing

Features and Advantages

• Fits standard Boomer, ROC and Mustang rigs.
• Particularly suitable for difficult ground conditions.
• A high rate of installation since drilling, placing and grouting can be performed in one single operation.
• Self drilling system eliminates the requirement  for a cased borehole.
• Installation with simultaneous drilling and grouting possible.
• Easy installation in all directions, also upwards.
• Suitable for working in limited space, height and in areas of difficult access.
• Simple post grouting system.• Hot-dipped galvanizing for corrosion protection

Technology Process
1. Connect the alloy drill and anchor rod one end, on the other end, connect the drill sleeve and shank adapter ,then connect the drilling rig or hand-held drill. Then start drilling, fill the cooling water while drilling.( If you want to lengthen the anchor rod, can connect the coupling, and then drilling)
2. Take down the drill, put the stop-grouting plug into the rod, and insert it to the hole, then ready to grout. Special circumstances like surrounding rock grouting tension is over or surrounding rock is too broken, can use anchor agent to seal the hole.
3. Connect quick grouting coupling and anchor rod end, connect other end of grouting machine.
4. Start grouting, when grouting full and reach design value then power off . Grouting pressure according to the design parameters and grouting machine performance determine ,Cement/sand reference values is 1:0 ~ 1:1, water/cement reference value is 0.45:1 ~ 0.5:1.
5. Install anchor plate and nuts, and tighten nuts.